Mixed tee 90º PVC for gluing and threading
- Mixed 90º PVC tee to be glued and threaded
- PVC-U fittings for pipe branching
- Glue female and thread female
- Dimensions from 20 x 1/2" to 110 x 4"
PVC Tees
The PVC pressure tee is an accessory used to make a derivation in the conduction of fluids. This Cepex accessory according to the EN 1452 standard offers the highest quality and guarantee for the conduction of pressurized liquids, as demonstrated by the certifications: AENOR, AFNOR, NF....
PVC-U tees are perfect for fluid conduction and pipe joining. In this case it is a 90º angle tee, glued on one side (female) and threaded on the other side (female), we recommend the use of glue to glue PVC-U fittings. We recommend the use of PTFE tape to guarantee the watertightness of the threaded fittings.
We have a wide variety of sizes of 90º tees from 20 x 1/2" to 110 x 4" diameter. Choose the one that best suits your installation.
Cepex fittings provide resistance both in pressure and chemistry, so they can be used in water, chemical and waste pipelines, among other sectors.
Dimensions 90º mixed tee
The following table shows the outer diameter, normal pressure and references of the 90º mixed tees.
Consult the following table for the dimensions of the threaded and glued mixed tees according to the outside diameter.
Pressure / temperature diagram
- Diameter
- 32 x 1”
40 x 1¼”
50 x 1½”
63 x 2”
75 x 2½”
90 x 3”
110 x 4”
140 - Angle
- 90º
- Union
- Mixto
- Diámetro combinado
- 20 x ½”
25 x ¾”