Tee 45º PVC for gluing
- 45º PVC tee to be glued
- PVC-U fittings for pipe branching
- Pressure resistance and chemical resistance
- Dimensions from D20 to D110
Receive it between Tue 24 and Thu 26
Alexandre André G. published the 02/05/2024 following an order made on 22/04/2024
Recomendo
PVC parts for swimming pools
The PVC pressure tee is an accessory used to make a derivation in the conduction of fluids. This Cepex accessory according to the EN 1452 standard offers the maximum quality and guarantee for the conduction of liquids under pressure, as demonstrated by the certifications: AENOR, AFNOR, NF....
The PVC-U tees are perfect for the conduction of fluids and the union in the pipes is made by gluing, so we recommend the use of glue.
In this case this tee has an angle of 45º and we have a wide range of sizes from 20 mm diameter up to 110 mm diameter to make the necessary derivations in each installation.
Thanks to the PVC-U material of the fittings, they offer both pressure and chemical resistance for use in water, chemical and waste pipelines, among other sectors.
Dimensions 45º Tee to be glued
The following table shows the outer diameter, normal pressure and references of the 45º tees:
Consult the following table for the dimensions of the 45º tees for gluing according to the outside diameter.
Pressure / temperature diagram
- Diameter
- 20
25
32
40
50
63
75
90
110 - Angle
- 45º
- Union
- Gluing